Sealing Joints Between Ducts – It’s a Snap with Our Leak-free Gaskets

Components of the Oil Mist System

The molded Nitrile Leak-free Gasket slips easily onto one end of the duct and is connected with a standard QF Clamp to form a tight and re-useable seal. Note the direction of the airflow when installing the duct.

Contact Nordfab

Wipe rolled edge with clean cloth. Then apply a high tack gasket adhesive per the manufacturer’s instructions. High tack gasket adhesives can be purchased locally at industrial or automotive suppliers in either aerosol spray or brushable formulations.
 
Carefully place the gasket along the rolled edge of the part, being careful to avoid kinks or voids. Only one gasket is needed per joint.
 
Join the gasketed end of the pipe to a non-gasketed end of the next part in the ducting run using a standard QF Clamp. The oil-mist gasket, in addition to the gasket inside the QF Clamp, provides dual protection against leakage.
 
Leak-Free Gasket 
◾General purpose oil resistant polymer
◾Performs well with many oil, water and hydraulic fluid applications
◾Good tear resistance
◾Available in 4”-10” diameter. Only even sizes in 12”-24” diameter
◾Should not be used with solvents such as acetone, MEK, ozone, chlorinated hydrocarbons, and nitro hydrocarbons
◾Conducts electricity
 
The QF Leak-free O-ring for use with our Adjustable-Length Duct

The Nordfab Adjustable Nipple provides unlimited flexibility in the length of a duct run.

  1. Cut a standard piece of QF Pipe to length and insert it into the short Adjustable Nipple section. This assembly will telescope to any length. Place the standard Adjustable Nipple O-ring and then the Leak-free O-ring onto the cut (inside) piece of pipe and seat the Leak-free O-ring evenly against the rolled metal edge of the Adjustable Nipple.
  2. Seat the Adjustable Nipple o-ring seal against the outside of the Leak-free O-ring. The order should be as follows: a) rolled edge of nipple; against b) Leak-free O-ring (smaller diameter o-ring); against c) standard Nordfab O-ring.
  3. Finally clamp the standard QF clamp over the rolled metal edge of the Adjustable Nipple and the O-rings for a leak-free connection. (Make sure both seals fit completely under the QF Clamp and that the air flows from the cut pipe towards the Adjustable Nipple).
 
Leak-Free O-ring
◾Resists corrosion from weather
◾Performs well with many oils and chemicals
◾Can’t be damaged by flexing and twisting
Standard O-ring
◾Recommended for petroleum oils and fluids,water, greases, and oils
Sealed Parts – High Quality Duct with Epoxy Caulking

Nordfab Reducer with oil mist caulkNordfab Ducting’s laser welded longitudinal seams are guaranteed to be leak proof. To ensure that other welds and gores on branches, elbows, and other custom parts are leak-free, Nordfab applies an epoxy caulking along the seams and joins. These parts can be installed in seconds using the standard QF Clamp and the between-the-joint gaskets.

 
*Due to variables beyond our control, Nordfab Ducting cannot guarantee a leak proof system in all installations, even when using the Epoxy caulk & “leak free” gaskets. Some of the variables that impact this include: the craftsmanship of the duct installation, the chemicals within the duct, and the expertise of the designer.

© Nordfab 2019 | About Us  | Contact Nordfab UK